HARMAN KARDON HKTS6
Instrukcja Serwisowa

HKTS5/HKTS6
SUB-TS5/TS6 Amplifier
LINE VOLTAGE US 120vac/60Hz Parameter Amp Section Type (Class AB, D, other) Load Impedance (speaker) Rated Output Power THD@ Rated Power THD @ 1 Watt DC Offset Damping factor Input Sensitivity Input Frequency SUB Input Signal to Noise SNR-A-Weighted SNR-unweighted SNR @ 1W-unweighted Residual Noise Floor Residual Noise Floor Yes/No Yes Specification

harman/kardon
100w Powered Subwoofer Amplifier
Notes Normal Operation Conditions Notes

Hi/Lo Line Unit 108-132 Vrms Unit QA Test Limits

AB AB 4 Ohms 100 Watts 0.08 % 0.1 % 10 mV-DC >100 DF

n/a n/a 95 0.3 0.5 20 50

Nominal 1 input driven 22k filter 22k filter @ Speaker Outputs

External Sink required for Class AB Z-curve required

Measured at speaker terminals, Output power 90 Watts THD 0.1 % Nominal Freq. To Rated Power 1 input driven SUB input driven only

50 Hz 135 mVrms 100 80 60 1.5 1 dBA dBr dBr mVrms
mVrms(max)

50 ±2dB 90 75 55 2.5 2

rel. to rated power A-Weighting filter rel. to rated power 22k filter rel. to 1W Output 22k filter Volume @max, using RMS reading DMM/VOM (or A/P) Volume @max, w/ A/P Swept Bandpass Measurement (Line freq.+ harmonics) Nominal

Input Impedance SUB Line input Filters Low Pass (fixed or variable) Slope & Q Subsonic filter (HPF) Slope & Q Limiter (yes/no) Features LFE Input Phase Switch (yes/no) Volume pot Taper (lin/log) ATO Input Configuration SUB Line level Signal Sensing (ATO) Auto-Turn-On (yes/no) ATO Input Frequency ATO Level ATO Turn-on time Auto Mute/ Turn-OFF Time Power on Delay time Transients/Pops ATO Transient Turn-on Transient Turn-off Transient Efficiency Stand-by Input Power

>15 K ohms fixed -dB/Octave Hz dB/Octave --

n/a ±2dB n/a ±2dB n/a n/a functional functional functional functional functional

YES YES NO log YES LFE YES 50 Hz 2 mV 5 ms

BW Limited to 500 Hz

---

Single RCA Input

--

functional functional functional functional functional functional 10 100 100 15 2mV@50Hz into Line Input w/ 1 ch. driven Amp connected and AC on, then input signal applied T before muting, after signal is removed Auto turn of time (T) must be 10 > T <15 AC Power Applied @ Speaker Outputs @ Speaker Outputs @ Speaker Outputs @ nom. line voltage

15 minutes 3 sec. 5 mV-peak 50 mV-peak 50 mV-peak 13 Watts

AC Line cycled from OFF to ON AC Line cycled from ON to OFF Maximum allowable input power under nominal Input voltage and frequency, HOT or COLD operation. 100 Watts @ 4 Ohms nominal line voltage

Power Cons.@rated power Protection Short Circuit Protection Thermal Protection DC Offset Protection Line Fuse Rating

185 Watts YES 65 deg. C ---

195 functional functional functional 2.5

@ nom. line voltage Direct short at output @1/8 max unclipped Power DC present at Speaker Out leads Type-T or Slo Blo

YES -2.5 Amps

Temperature rise should not exceed 35K rise Relay or crowbar (for driver/fire protection) External fuse with UL/SEMKO rated holder

2